Fanuc Alarm 231 ILLEGAL FORMAT IN G10 OR L50
Fanuc Alarm Description
Any of the following errors occurred in the specified format at the programmable– parameter input.
1 Address N or R was not entered.
2 A number not specified for a parameter was entered.
3 The axis number was too large.
4 An axis number was not specified in the axis–type parameter.
5 An axis number was specified in the parameter which is not an axis type. Correct the program.
6 An attempt was made to reset bit 4 of parameter 3202 (NE9) or change parameter 3210 (PSSWD) when they are protected by a password.
Correct the program.
Applies to
Fanuc CNC Controls
- 21 Model B