Okuma Alarm-C 3724 Main program start
When the machine was linked with a robot/loader through the interface type B and the main program operation mode was selected, the linked operation was attempted.
Code
None->above
1->Program No. between NC and tail-stock absolute coder are not same in cycle start
2->After tool change and measurement, main program start was attempted without check button.
3->Main program start was attempted by external start switch, when machine was not cycle start position.
4->Main program start was attempted without door sensor.
5->Main program start was attempted by NC starat button, when machine was not cycle start position.
6->When program No. between NC and Loader were not same, cycle start was about to be done.
Probable Faulty Locations
1)The machine is linked with a robot/loader.
2)The schedule program operation mode is not selected.
Measures to Take
1)Set off the link switch.
2)Select the schedule program.