Okuma Alarm-C 3735 Next tool preparation impossible
The MT command could not be accepted.
The tool specified by the MT command does not exist in the magazine.
Code
None->The MT command could not be accepted.
1->The tool shelf of the tool which MT command did not have a magazine pot.
2->The return of the magazine pot is not possible so that there is a magazine pot in the empty pot place.
3->Because the empty pot place does not have a magazine pot, I cannot receive the existing tool. The tool number that MT command wins with 0 When it is 0, and there is not the existing tool, I take out a magazine pot from the empty pot place and receive the existing tool.
Because the empty pot place does not have a magazine pot, I cannot receive the existing tool.
4->Because a empty pot place does not have a magazine pot, I cannot receive an existing tool. The tool number that MT command wins with 0 An existing tool takes out a magazine pot in the case of 0 from a empty pot place and receives the existing tool. Because the empty pot place does not have a magazine pot, I cannot receive an existing tool.
5->The specified tool exists on the tool setup.
13->The tool specified by the MT command does not exist in the magazine.
14->The tool specified by the MT command was found at two locations in the magazine.
17->MTS commands is specified to an angle tool.