Sinumerik Alarm 27222 PROFIsafe: S7 F module PROFIsafe address %1 unknown
Parameters:
%1 = PROFIsafe address
Definitions:
The F module with the specified PROFIsafe address has not been parameterized as an F module in the NCK MD.
Reactions:
– Mode group not ready.
– Channel not ready.
– NC Start disable in this channel.
– NC Stop on alarm.
– Alarm display.
– Interface signals are set.
Remedy:
Check the S7 PROFIBUS configuration. Enter the module in the NCK MD.
Program Continuation:
Switch control OFF – ON.
References
- Siemens Diagnostics Guide by Siemens