Sinumerik Alarm 27223 PROFIsafe: NCK F module MD %1[%2] is not a %3 module
Parameters:
%1 = MD name
%2 = MD field index
%3 = Module type
Definitions:
The F module parameterized in the specified NCK MD has not been entered as input/out- put module in the S7 PROFIBUS configuration.
• %3 = INPUT:NCK F parameterization expects INPUT module
• %3 = OUTPUT:NCK F parameterization expects OUTPUT module
• %3 = IN/OUT:NCK F parameterization expects INPUT or OUTPUT module
Reactions:
– Mode group not ready.
– Channel not ready.
– NC Start disable in this channel.
– NC Stop on alarm.
– Alarm display.
– Interface signals are set.
Remedy:
Check the module in the S7 PROFIBUS configuration.
Program Continuation:
Switch control OFF – ON.
References
- Siemens Diagnostics Guide by Siemens