Sinumerik Alarm 61188 Channel %1 block %2 no axis name for the 1st axis assigned -> Check installation and start-up of the swivel cycle CYCLE800
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
No axis name was specified for the 1st rotary axis. Alarm triggered by following cycles: CYCLE800.
Reactions:
– Interpreter stop
– NC Start disable in this channel.
– Interface signals are set.
– Alarm display.
Remedy:
Check installation and start-up of the swivel cycle CYCLE800.
Program Continuation:
Clear alarm with the RESET key. Restart part program
References
- Siemens Diagnostics Guide by Siemens