Sinumerik Alarm 22100 Channel %1 block %3 spindle %2 chuck speed exceeded
Parameters:
%1 = Channel number
%2 = Axis name, spindle number
%3 = Block number, label
Definitions:
The actual speed of the displayed spindle is greater than the value entered in the axis- specific machine data 35100 SPIND_VELO_LIMIT plus the tolerance value specified in machine data 35150 SPIND_DES_VELO_TOL. If the drive actuator has been optimized properly, the alarm cannot occur in the 840D! The alarm can be reprogrammed in the MD ALARM_REACTION_CHAN_NOREADY (channel not ready).0
Reactions:
– Alarm display.
– Interface signals are set.
– Mode group not ready.
– Channel not ready.
– Channel not ready.
– NC Stop on alarm.
– NC Start disable in this channel.
– If the axis is a single axis when this alarm is triggered, the alarm is only effective for this axis (not effective for e.g. the channel or mode group)
Remedy:
Please inform the authorized personnel/service department. Check the setup and optimization data of the drive actuator in accordance with the Installation and Start-up Guide and make corrections. Increase the tolerance window in machine data 35150 SPIND_DES_VELO_TOL.
Program Continuation:
Clear alarm with the RESET key in all channels of this mode group. Restart part program.
References
- Siemens Diagnostics Guide by Siemens