Sinumerik Alarm 27034 Parameterization of MD %1 invalid
Parameters:
%1 = MD identifier
Definitions:
The parameterization of %1 is incorrect. This alarm occurs in the following context: an incorrect value was entered for MD $MN_SAFE_ALARM_SUPPRESS_LEVEL.
Reactions:
– Mode group not ready.
– Channel not ready.
– NC Start disable in this channel.
– NC Stop on alarm.
– Alarm display.
– Interface signals are set.
Remedy:
Check the specified machine data.
Program Continuation:
Switch control OFF – ON.
References
- Siemens Diagnostics Guide by Siemens