Sinumerik Alarm 61000 Channel %1 block %2 no tool compensation active
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: LONGHOLE, SLOT1, SLOT2, POCKET1 to POCKET4, CYCLE71, CYCLE72, CYCLE90, CYCLE93 to CYCLE96.
Reactions:
– Alarm display.
– Interface signals are set.
– NC Start disable in this channel.
– Interpreter stop
Remedy:
D-correction must be programmed before the cycle call.
Program Continuation:
Clear alarm with the RESET key. Restart part program
References
- Siemens Diagnostics Guide by Siemens