Sinumerik Alarm 61121 Channel %1 block %2 number of teeth per cutting edge missing
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
No value was entered for the number of teeth per cutting edge. Alarm triggered by following cycles: CYCLE70.
Reactions:
– Interpreter stop
– NC Start disable in this channel.
– Interface signals are set.
– Alarm display.
Remedy:
Enter the number of teeth/cutting edges for the active tool into the tool list.
Program Continuation:
Clear alarm with the RESET key. Restart part program
References
- Siemens Diagnostics Guide by Siemens