Sinumerik Alarm 61124 Channel %1 block %2 infeed width is not programmed
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycle: CYCLE71.
Reactions:
– Alarm display.
– Interface signals are set.
– NC Start disable in this channel.
– Interpreter stop
Remedy:
With active simulation without tool, a value for the infeed width _MIDA must always be programmed.
Program Continuation:
Clear alarm with the RESET key. Restart part program
References
- Siemens Diagnostics Guide by Siemens