Sinumerik Alarm 61803 Channel %1 block %2 programmed axis not present
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The programmed axis is not in the system. Alarm triggered by following cycles: CYCLE83, CYCLE84, CYCLE840.
Reactions:
– Interpreter stop
– NC Start disable in this channel.
– Interface signals are set.
– Alarm display.
Remedy:
Check parameter _AXN. Check MD20050-20080.
Program Continuation:
Clear alarm with the RESET key. Restart part program
References
- Siemens Diagnostics Guide by Siemens