Sinumerik Alarm 301716 Axis %1 drive %2 SSI direct measuring system without incremental signals not possible
Parameters:
%1 = NC axis number
%2 = Drive number
Definitions:
With the present module, it is not possible to use SSI encoders without incremental signals.
Reactions:
– Mode group not ready.
– Channel not ready.
– NC Start disable in this channel.
– NC Stop on alarm.
– Alarm display.
– Interface signals are set.
Remedy:
Use newer module. Program Continuation: Switch control OFF – ON.
References
- Siemens Diagnostics Guide by Siemens