Sinumerik Alarm 310710 Axis %1 drive %2 distance-coded scale incorrectly parameterized
Parameters:
%1 = NC axis number
%2 = Drive number
Definitions:
If a distance-coded scale is selected (MD 5011 bit 7=1) a length measuring system must also be configured (MD 5011 bit 4=1).
Reactions:
– Mode group not ready.
– Channel not ready.
– NC Start disable in this channel.
– NC Stop on alarm.
– Alarm display.
– Interface signals are set.
Remedy:
Check and, if necessary, correct MD 5011: ACTUAL_VALUE_CONFIG (actual value sensing configuration).
Program Continuation:
Switch control OFF – ON.
References
- Siemens Diagnostics Guide by Siemens