Home Fanuc Learn Examples Sinumerik Haas Reference Alarms Programming About

Okuma Alarm-P 0996 PLC axis data file


Okuma Alarm-P 0996 PLC axis data file
The PLC axis control constants do not match the machine specifications.

Index
None

Character-string
PLC axis name

Code
1:U100->None

7030->The axis names downloaded from PLC axis data file do not match the actually mounted axis names.

2:U100->This file open error

7030->The file type is not “PBU1”.

3:U100->The file reading error(header,axis data1)

7030->The file has too large DB.

4:U100->The file attribute error (file affribute is not “PBU1”)

7030->The specification data in the PLC axis data file is different from that in the SVP data file.

5:U100->The file closed error

7030->Memory location table of the axis backup data of the PLC axis data file is not found.

6:U100->The file has too large.

7030->Memory location table of the axis parameters of the PLC axis data file is not found.

7:U100->The file reading error(axis data2,3)

7030->An error occurred when opening the PLC axis data file. File is short.
File name or device name is incorrect.

8:U100->The axis name unjust error.

7030->Although the axis name in the PLC axis data file is the Okuma specification name, it differs from the registered name.

9:PLC axis data file is too small.
15:The number of PLC axes exceeds 8.
16:PLC axis number exceeds 8.
17:Rotary axis gear transmission ratio of the master axis is 0 although the axis hangeover specification (function generation specification B bit 0) is set.
18:Rotary axis gear transmission ratio of the slave axis is 0 although the axis changeover specification (function generation specification B bit 0) is set.
19:Pitch data of the master axis is 0 although the axis changeover specification (function generation specification B bit 0) is set.
1A:Pitch data of the slave axis is 0 although the axis changeover specification (function generation specification B bit 0) is set.
1B:Rotary axis specification (servo data file) is not set although the point positioning specification (function generation specification B bit 6) is set.
1C:Linear axis specification (servo data file) is not set although the arbitrary positioning specification (function generation specification B bit 7) is set.
1D:For OSP7030 / OSP730, the master axis of the axes with an independent position sensor is not found, or the master axis is not set.
1E:For OSP7030 / OSP730, multiple axes are specified as the master axis of the axes with an independent position sensor.
1F:For OSP7030 / OSP730, detected speed of the axis with an independent position sensor is 0.

This data is set by MCS when the power is turned on.

20:For OSP7030 / OSP730, the rotary axis gear transmission ratio (EQDGT) or the convert factor (ESRDGT) of the axis with an independent position sensor is not set. (setting value: 0)
21:For OSP7030 / OSP730, it was designated in concurrense with the axis changeover specification and the table changeover specification

Probable Faulty Locations
Error in creation of PLC axis data file
21…Power is shut off during axis changeover control.

Okuma Alarm-P 0996 PLC axis data file