Okuma Alarm-B 2445 3-D coordinate conversion

Okuma Alarm-B 2445 3-D coordinate conversion
G303/G302 command is wrong.

Object
SYSTEM

Code
1->G303/G302 command is designated though the 3-D Coordinate conversion specification is not provided.
2->CP instruction is outside the range.

3->CQ instruction is outside the range.

4->CR instruction is outside the range.

5->H instruction is outside the range.

6->It instructed in X/Y/Z/CP/CQ/CR and H when instructing in G303 at the same time.
7->Rotation axis (CP/CQ/CR) was not instructed in when instructing in G303. Or, there were two rotation axis instructions or more in the same block.
8->It instructed in G303 H when the 3-D Coordinate parameter was a unsetting.
9->It instructed in G11 as follows.

10->It instructed in the G302/G303 mode as follows.

11->All X/Y/Z are not instructed in by the first axis movement instruction after the offset(zero offset, zero shift, and tool offset) is changed.

Probable Faulty Locations
Incorrect program

Measures to Take
Correct the program.