Sinumerik Alarm 4340 Channel %1 block %2 invalid transformation type in transformation no. %3
Parameters:
%1 = Channel number
%2 = Block number, label
%3 = Transformation number
Definitions:
An invalid, i.e. undefined, number was entered in one of the machine data TRAFO_TYPE_1 … TRAFO_TYPE_8. This alarm also occurs if a certain type of transformation is only impossible on the type of control used (e.g. 5-axis transformation on a SINUMERIK 802D).
Reactions:
– Alarm display.
– Interface signals are set.
– Correction block is reorganized.
– NC Stop on alarm at block end.
Remedy:
Enter a valid transformation type.
Program Continuation:
Clear alarm with the RESET key. Restart part program
References
- Siemens Diagnostics Guide by Siemens