Sinumerik Alarm 10960 Channel %1 block %2 COMPCURV/COMPCAD and radius compensation cannot be used simultaneously
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Compressor types COMPCURV and COMPCAD cannot be used in combination with tool radius compensation. Only compressor type COMPON can be activated while tool radius compensation is active.
Reactions:
– Local alarm reaction.
– Alarm display.
– Interface signals are set.
– Correction block is reorganized.
– NC Stop on alarm at block end.
Remedy:
Modify part program.
Program Continuation:
Clear alarm with NC START or RESET key and continue the program.
References
- Siemens Diagnostics Guide by Siemens