Sinumerik Alarm 14033 Channel %1 block %2 involute: no end point programmed

Sinumerik Alarm 14033 Channel %1 block %2 involute: no end point programmed

Parameters:
%1 = Channel number
%2 = Block number, label

Definitions:
No end point was programmed for the involute. This is either possible via direct programming with the geometry axis identifiers or by specifying the angle between start and end vector.

Reactions:
– Alarm display.
– Interface signals are set.
– Correction block is reorganized.

Remedy:
Modify part program.

Program Continuation:
Clear alarm with NC START or RESET key and continue the program.