Sinumerik Alarm 14280 Channel %1 block %2 polar coordinates programmed incorrectly
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The end point of the displayed block has been programmed both in the polar coordinate system (with AP=…, RP=…) and in the Cartesian coordinate system (axis addresses X, Y,…).
Reactions:
– Alarm display.
– Interface signals are set.
– Correction block is reorganized.
Remedy:
Correct the NC part program – the axis motion may be specified in one coordinate system only.
Program Continuation:
Clear alarm with NC START or RESET key and continue the program.
References
- Siemens Diagnostics Guide by Siemens